Overview

The FX51 array game utilizes Escape Room Techs’ FX51SEN sensors to detect the rotation of one or more objects (i.e. knobs, prop pieces). When all the pieces are rotated within the programmed threshold, the prop solves.

Included in the standard firmware.

Hardware Requirements

Configuration

Learn sensors as described in Learning.

Center (Degrees):
The trigger point where a sensor is matched. When all sensors are matched the prop is solved. Use current angle to determine trigger point.

Trigger Width (Degrees):
The range in degrees +/- around the center to consider matched. I.e. if center is 180 and trigger width is 10, sensor will be matched between 170-190 degrees.

Learning

Accessed via game tab and learning button.

Wire your sensors as described in the diagram below. They should then show up on the learning page under Detected Sensors. Click "Save Detected Sensors" to save the setup. They should now appear in Stored Sensors. Return to the Game tab to configure.

Wiring

Each FX51SEN must have a unique address (different switch settings)!
Diagram shows 4 sensors but 1-10 may be used.

drawing

Notes